4 screws to remove from inside. One shown here. One on other side of metal housing, same for other license plate light area.
Backup camera cable routed through license plate light housing. LI connectors too big to make that work.
Location of plastic tabs to release assmebly
Removal of handle assembly
Dremel notch out of plastic
Dremel notch out of metal behind plastic
Cut off ends of plastic sensor mount.
Cut notch in license plate light surround.
Cut two notches, then use needle nose pliers to remove. Finally, file smooth.
Cable goes through to interior unobstructed.
Cleaned up and ready to be remounted.
Repainted backup camear mount plate.
Mounted with silcone and properly angled.
Need to use coat hanger to guide wires. Feed in from bottom first, then attach wire, and pull back through.
Cut small hole and pull cables through here.
Silicone to seal.